The nanowires do not stick to this top PET film because of the initial room temperature rolling step. Figure 1b shows the

schematic of the hot-rolling process. As reference samples, some electrodes were not pressed but instead annealed in a furnace at 100°C for 30 min, which is a common way of preparing silver nanowire electrodes [7, 19]. Figure 1 Rolling Nutlin-3a in vitro process of the nanowire electrodes. (a) The hot-rolling press. (b) Schematic of the rolling process. Characterization The sheet resistance of the electrodes was measured by either a four-point probe measurement or a multimeter. The transparencies were recorded with a spectrophotometer, with plain PET as a reference. Atomic force microscopy (AFM) was used to measure surface roughness, and

peak-to-valley values were extracted from line scan data collected by Gwiddion software. Tilted scanning electron microscopy (SEM) buy Crenolanib images were taken of the electrodes, which had been coated with a 10-nm gold layer to prevent electron charging. To determine the level of adhesion, a piece of scotch c-Met inhibitor tape was applied on the silver nanowire film, pressed with a finger, and then peeled off, with the sheet resistance of the electrode being measured before and after. Bending tests were done by bending the electrodes around a rod with a 5-mm radius. The sheet resistance of the electrodes was measured before, after, and during the bending. Results and discussion The rollers’ temperature, speed, and spacing were optimized to minimize the surface roughness of the electrode without damaging the silver nanowires and the substrate. A rolling temperature of 80°C was the maximum that the substrate could tolerate before deforming.

The rolling speed of 5 mm/s allowed enough time for the substrate to heat up and soften during rolling. Figure 2 shows SEM images of an unpressed, annealed reference sample and a hot-rolled electrode. It can be seen that the hot-rolled nanowires are pushed into the substrate with the nanowires remaining at the surface so that they can contact a device layer above it. The annealed electrode had a sheet resistance of 22 Ω/sq with a specular almost transparency of 93% at 550 nm, while the hot-rolled electrode with the same density of nanowires had a sheet resistance of 14 Ω/sq, with 91% transmittance. Figure 2 indicates that hot rolling welds overlapping wires, which lowers the resistance of the nanowire junctions and explains the 35% lower sheet resistance of the hot-rolled electrodes. In contrast, the junctions on the annealed sample are not completely welded; an annealing temperature higher than 100°C cannot be used because of the plastic substrate. The transparency of the hot-rolled electrode was slightly lower than that of the annealed one, which may be due to a slight flattening of the nanowires.